Nor-lake AdvantEDGE Bottom Mount Merchandisers Manuel d'utilisateur télécharger pdf

08/13 Rev. B 146528

BOTTOM MOUNT MERCHANDISERS

Installation, Operation and Maintenance

Instructions

INSPECTION

When the equipment is received, all items should be carefully checked against the Bill

of Lading to insure all crates and cartons have been received. Do not sign the freight

bill clear until the freight has been properly inspected for damage. All units should be

inspected for damage including concealed damage by uncrating immediately. If any

damage is found, it should be reported to the carrier at once, noted on the Bill of Lading

and a claim should be filed with the carrier. This equipment has been inspected and

tested in the manufacturing facility and has been crated in accordance with

transportation rules and guidelines. The manufacture is not responsible for freight loss

or damages.

INSTALLATION

The exterior of the cabinet and doors have been protected by a plastic covering. Peel

this protective covering before installation. After removing the covering, clean the

interior and exterior surfaces of the unit with soap and water and a rinse with clean

water. Do not use chlorinated cleaners on the surfaces as they can cause corrosion.

If the door(s) have come out of alignment during shipping they will need to be adjusted.

This can be accomplished by opening the door(s) and loosening the screws that hold

both the top and bottom hinges to the cabinet. After adjusting the door so it is aligned

correct, tighten the screws to securely hold the hinges and door(s) in place.

The shelves and self clips are packaged inside the unit. Install the shelf clips on the

pilasters inside the unit and set the shelves on the clips. The shelves are adjustable in

½” increments. One (1) shelf can support up to 60 kg.

The refrigeration system located at the bottom of the unit requires free air access for

proper operation. Allow a minimum of seven inches between the back of the cabinet

and the wall. Do not locate the unit next to heat generating equipment or in direct

sunlight.

Confirm that the proposed electrical outlet has the correct voltage, frequency and

current carrying capacity for the requirements of the unit. This information is noted on

the data plate on the inside left wall of the unit. The unit should be isolated on a circuit.

Do not use an extension cord to get power to the unit. Improper electrical installations

will void the compressor warranty. To prevent shock and fire, be sure the unit is properly

grounded.

1 2 3 4

Résumé du contenu

Page 1 - Instructions

08/13 Rev. B 146528 1 BOTTOM MOUNT MERCHANDISERS Installation, Operation and Maintenance Instructions INSPECTION When the equipment is receiv

Page 2 - MAINTENANCE

08/13 Rev. B 146528 2 The refrigerators are supplied with adjustable legs for leveling purposes. To provide adequate drainage and proper door op

Page 3 - TROUBLESHOOTING

08/13 Rev. B 146528 3 TROUBLESHOOTING Problem Remedy Compressor will not start · Check the power cord and make sure it is plugged in. · Check t

Page 4 - SPECIFICATIONS

08/13 Rev. B 146528 4 SPECIFICATIONS PRODUCT REACH-IN MERCHANDISERS MODEL GR26H GR48S GR70H Capacity (CuFt) 23 CuFt (676 liter) 46.2 CuFt

Commentaires sur ces manuels

Pas de commentaire

Nor-lake AdvantEDGE Bottom Mount Merchandisers Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Réfrigérateurs Nor-lake AdvantEDGE Bottom Mount Merchandisers. Nor-Lake AdvantEDGE Bottom Mount Merchandisers User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Réfrigérateurs Nor-lake AdvantEDGE Bottom Mount Merchandisers