Nor-lake Undercounter & Freestanding Refrigerators Manuel d'utilisateur télécharger pdf

UNDERCOUNTER & FREESTANDING

REFRIGERATOR

Installation, Operation and

Maintenance Instructions

INSPECTION

When the equipment is received, all items should be carefully checked against the bill of lading to

insure all crates and cartons have been received. All units should be inspected for concealed

damage by uncrating the units immediately. If any damage is found, it should be reported to the

carrier at once, and a claim should be filed with the carrier. This equipment has been inspected and

tested at the manufacturing facility and has been crated in accordance with transportation rules and

guidelines. Manufacturer is not responsible for freight loss or damage.

Before connecting the refrigerator to the power supply, let it stand for approximately two hours to

reduce the possibility of malfunctions in the cooling system due to transport handling

INSTALLATION

GENERAL

After the unit crate and crate base have been removed, place the refrigerator firmly on a solid base.

Adjust the adjustable feet on the front of the cabinet to level the refrigerator (see Figure 1). The

ventilation grid may be placed close to a wall as the grid allows for sufficient air circulation required

for adequate ventilation (see Figure 2). For total enclosure, allow 2 inches of clearance all around

for ventilation.

Figure 1 Figure 2

ELECTRICAL

Check the proposed outlet to be used to insure that the voltage, phase, and current carrying

capacity of the circuit from the electrical panel correspond to the requirements of the cabinet.

NEVER use an extension cord to wire any unit. Refer to the serial tag for all pertinent electrical

information.

Observe all Warning Labels. Disconnect power supply to eliminate injury from electrical

shock or moving parts when servicing equipment.

9/09 133288

1 2 3 4

UNDERCOUNTER & FREESTANDING REFRIGERATOR Installation, Operation and Maintenance Instructions INSPECTION When the equipment is received, all

OPERATION The refrigerator is controlled with a thermostat knob located on the right upper interior wall of the appliance. Higher settings on the kn

• Check the resting of the magnetic seals. The seal must not be creased thereby ensuring a good seal. 1 Upper hinge pi

Page 4

4 9/09 133288 of the system. A brush with non-metal stiff bristles can be used to loosen particles so that they may be removed with a vacuum cleaner.

Pas de commentaire

Nor-lake Undercounter & Freestanding Refrigerators Manuel d'utilisateur