Nor-lake General Laboratory Refrigerators & Freezers Manuel d'utilisateur télécharger pdf

GENERAL LABORATORY

REFRIGERATORS AND FREEZERS

Installation, Operation and

Maintenance Instructions

INSPECTION

When the equipment is received, all items should be carefully checked against the bill of lading to

insure all crates and cartons have been received. All units should be inspected for concealed

damage by uncrating the units immediately. If any damage is found, it should be reported to the

carrier at once, and a claim should be filed with the carrier. This equipment has been inspected and

tested in the manufacturing facility and has been crated in accordance with transportation rules and

guidelines. Manufacturer is not responsible for freight loss or damage.

INSTALLATION

GENERAL

After the unit crate and crate base have been removed, locate the casters or legs found inside the

cabinet. Attach the casters or legs to the unit base by screwing them into the same threaded fittings

that were used to secure the crate base to the cabinet. Insure that the legs or casters are screwed

completely into the base.

If for some reason the doors are not squared up on the cabinet, the doors can be adjusted. Opening

the door(s) and loosening the screws that hold both the top and bottom hinges to the cabinet can

accomplish this. After adjusting the door so that it is aligned correctly, tighten the screws to securely

hold the hinges in place.

VAPORIZER INSTALLATION

The General Laboratory forced air models require the installation of the condensate vaporizer,

which is shipped inside the unit compartment. The vaporizer should be mounted to the cabinet

bottom. Reference View 1. In lieu of the vaporizer, these units can be plumbed to a floor drain

following local plumbing codes. The cold wall units do not use a vaporizer. Customer installation

is not required.

1 4/06 119503

1 2 3 4 5 6

Résumé du contenu

Page 1 - Maintenance Instructions

GENERAL LABORATORY REFRIGERATORS AND FREEZERS Installation, Operation and Maintenance Instructions INSPECTION When the equipment is received, al

Page 2 - GENERAL OPERATION

Note: Disconnect power prior to installation. 1. Connect the power cord to the vaporizer and place it in the vaporizer bracket. 2. Attach the

Page 3 - Photo - JPEG decompressor

Refrigerators During the operation of refrigerator units, frost will periodically form on the coil surface. Each time the compressor cycles "of

Page 4 - GENERAL MAINTENANCE

Figure 1 shows the time switch set to defrost at 2:00 a.m., 8:00 a.m., 2:00 p.m., and at 8:00 p.m. The fail-safe pointer indicates that the system

Page 5

All moving parts have been permanently lubricated and will generally require no maintenance. MAINTENANCE SERVICE AND ANALYSIS GUIDE REFRIGERATION

Page 6 - under pan area

under pan area 3. Too warm 3. Adjust temperature control - see instructions under pan area 6 4/06 119503

Commentaires sur ces manuels

Pas de commentaire

Nor-lake General Laboratory Refrigerators & Freezers Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Réfrigérateurs Nor-lake General Laboratory Refrigerators & Freezers. Nor-Lake General Laboratory Refrigerators & Freezers User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Réfrigérateurs Nor-lake General Laboratory Refrigerators & Freezers